Renesas Emulator System E8 Manuale Utente Scaricare il pdf (Pagina 161)

Appendix E Diagnostic Hardware Program

This manual describes the troubleshooting procedure that applies the check program for the E8

emulator.

E.1. System Setup to Execute the Check Program

(1) The following equipments are required to execute the check program. Do not connect the user

system interface cable or the user system while the check program is running.

• E8 emulator station

• USB cable included with the E8 emulator

• CD included with the E8 emulator

• Host computer (hareafter, PC)

Install the High-performance Embedded Workshop and USB driver on the PC in

advance.

(2) Start up the host computer, and connect the E8 emulator to the USB connector of the host

computer via the USB cable attached. Prior to this, the user interface cable must be

disconnected.

E.2. Executing the Check Program

(1) Execute [Program]-[Renesas]-[High-performance Embedded Workshop]-[E8 Self Check

Program].

Figure E.1 Starting Up the Check Program

143

1 2 ... 156 157 158 159 160 161 162 163 164 165 166

Nessun commento

Renesas Emulator System E8 Manuale Utente Pagina 161