Renesas M3A-HS71 Manuale Utente Scaricare il pdf (Pagina 38)

Setting Up the Software

3.2.2 Setting Up the E10A-USB Emulator

Rev. 1.01 May 7, 2008

3-12

REJ11J0015-0101

(3) Press “Setup”(Figure3.2.9). The dialog box shown below will be displayed.

Figure3.2.12 Setup Tool for SHxxxx E10A-USB Emulator Dialog Box

(4) Set the emulator setup switch (SW1) to the “0” side, and temporarily remove the USB cable and plug it in back again.

Then click “OK”. The system will start setting up the E10A-USB emulator firmware.

Figure3.2.13 System Starts Setting Up the Firmware

CAUTION

• Do not turn off the power for the host computer or remove the USB cable while the system is

setting up the E10A-USB emulator. Such an act may cause the E10A-USB emulator to break

down.

(5) When the dialog box shown below is displayed, it means that the system has finished setting up the E10A-USB

emulator normally.

Figure3.2.14 Setup Completion Message

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 81 82

Nessun commento

Renesas M3A-HS71 Manuale Utente Pagina 38