Renesas User System Interface Board HS1664ECH61H Informazioni Techniche Scaricare il pdf (Pagina 27)

Section 3 Connection Procedures

Rev. 1.00 Nov. 18, 2008 Page 9 of 20

REJ10J1936-0100

3.1.3 Connecting Common User-System Interface Adaptor Cable (Board Unit) to the

EV-Chip Unit

WARNING

Observe the precautions listed below. Failure to do so

will result in a FIRE HAZARD and will damage the user

system and the emulator product or will result in

PERSONAL INJURY. The USER PROGRAM will be

LOST.

1. Always switch OFF the user system and the emulator

product before the USER SYSTEM INTERFACE CABLE

is connected to or removed from any part. Before

connecting, make sure that pin 1 on both sides are

correctly aligned.

2. The user system interface cable dedicated to the

emulator must be used.

1. Make sure the user system and emulator are turned off.

2. Align the connectors on the common user-system interface adaptor cable (board unit) with

those on the EV-chip unit according to their numbers (figure 4).

3. Use the spacers attached to the common user-system interface adaptor cable (board unit) to

adjust the height to match the situation of the user system.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 41 42

Nessun commento

Renesas User System Interface Board HS1664ECH61H Informazioni Techniche Pagina 27